Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Trailer arm bushings Help! 200

posted by  Kenner on  Wed Nov 29 16:29 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 24 15:42 CST 2014
[RELATED]

Built the tool, got the nerve, went ahead. Driver side went problem free. Had to torch every nut to break them loose but was fine Got the T arm off and took it to my local M/S and they pressed in a new front bushing for me. Installed new spring and shock too. Sweet.
Passenger side is a B####. Torched all the nuts and got the arm off no problem. But the rear bushing won't budge for nothing. I pushed the innards out but man it is seized bad. 1/2" drive impact @120PSI and it doesn't move a bit. I am soaking it overnight in Krown. Tomorrow a yank the exhaust to get a better reach.
Does anyone have ideas for me? I am reluctant to torch it as the e/brake housing is right there and made of plastic and is hard to remove. Should I cut it in half or cut a section out of it and hacksaw it or something. Anyone?
It is turning nasty cold here on Friday so I want to finish tomorrow
--
91 Brick turning 400,000 this month






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Trailer arm bushings Help! [200]
posted by  Kenner  on Wed Nov 29 16:29 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.