Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Leaking coolant around thermostat housing after thermostat change 200 1988

posted by  MrBrett66 on  Mon Dec 11 07:47 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 22 21:35 CST 2007
[RELATED]

I replaced my thermostat and o ring seal when I flushed the coolant last summer. I have noticed a small trickle of coolant around the thermostat housing now. It's not even enough to leave a spot under the car, but I want to eliminate it completely. How tight should I tighten the bolts on the housing? I may have crushed the o ring, I guess. Also, should I use any rtv gasket on the housing? I don't have a torque wrench, so an answer giving a ballpark figure on tightness will be good. Brett






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Leaking coolant around thermostat housing after thermostat change [200][1988]
posted by  MrBrett66  on Mon Dec 11 07:47 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.