Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Heater blower resistor - can blower motor drag cause it to fail? 700 1991

posted by  dnastrau on  Thu Dec 21 09:51 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 5 19:39 CST 2011
[RELATED]

Hi everyone:

I wanted to see if anyone else has had an experience like this before...

A couple of months back I replaced the blower motor resistor on my '91 744 to cure the typical "no fan speeds except high" problem. I got the resistor from FCP Groton - it was about $65 IIRC. Problem solved - so it seemed.

Yesterday, I turned the blower on and I am back to the same problem - no speeds except for high! Is it possible that the fan motor is dragging causing the resistor to overheat and burn out? Is it possible that I got a poor/defective resistor that just didn't last? The one that came out looked original - not bad for 15 years and 162K+ miles.

I fear that I am looking at another new resistor as well as a new blower motor if that is what is causing them to fail. Not cheap if this is the case! Any thoughts are appreciated as always.

Thanks,

Andrew S.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Heater blower resistor - can blower motor drag cause it to fail? [700][1991]
posted by  dnastrau  on Thu Dec 21 09:51 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.