Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

A/C Compressor not lining up to crank pulley 200

uid 29404's pic
posted by  punk240 on  Sat Dec 23 15:57 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jul 14 15:23 CST 2014
[RELATED]

Today i removed the entire PS+AC bracket to replace all the accesory mount bushings - took about 30-40 mins.
Upon reassembly I couldn't get the pulleys to line up - consulted both Bently and Chilton and noted that the previous owner had some real "African Engineering" in the pulley config.
While following the Belt layout things just got worse.
The dual pulley for the AC was protruding way to far to the front (15-18mm).
Started looking at the cresent brackets under the compressor and noticed that they were on the inside of the flange-ears
Moved them to the outer side of the ears and i had about a 10 mm over-expansion to the bushings and the pulley was cock-eyed.
Threw a wratchet strap on the crank and AC pulleys and zipped it closer to line but crawled under to see the mounts were being warped!

Should the cresent brackets be on corresponding sides (fore /fore) or oppositional (fore/aft) ???

TIM






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New A/C Compressor not lining up to crank pulley [200]
posted by  punk240  on Sat Dec 23 15:57 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.