Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Brake hose replacement question 200 1986

posted by  Xraybob on  Tue Dec 26 23:53 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

When I did my brake overhaul last week, my new brake lines hadn't arrived yet, but now, all are here. I have the proper wrenches and brake fluid also. My question is, do I siphon all the fluid out of the fluid bottle over the master cylinder then open the lines when I remove them, or is there another way of removing all the fluid in the system so I don't make a big mess before I install the new brake lines? I'll be using my manual brake bleeding system that I've had for 32 years, my wife, helping me.
Thanks for your input and advice in advance.
--
'86 sedan with 354K miles with original engine and automatic transmission






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brake hose replacement question [200][1986]
posted by  Xraybob  on Tue Dec 26 23:53 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.