Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tie rod ends rusted into tie rod. 120-130

posted by  pearl on  Sun Jan 7 16:22 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 7 09:41 CST 2009
[RELATED]

In the process of doing a front end alignment I had to take out the tie rod to unfreeze one of the nuts so I could make the adjustment.
I replaced these ends about four years ago, but nonetheless one of them is really really frozen in there. Then I retrieved another I had in the basement. The ends of THAT one are both really really frozen.
So I tried a little rust breaker voo doo, which is alternating heat (propane) and BP Blaster. No give.
I can't even find a center tie rod for sale, although I'll probably wind up getting one or two ends before I'm done.
Anyone have any nifty tricks for getting those buggers out?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tie rod ends rusted into tie rod. [120-130]
posted by  pearl  on Sun Jan 7 16:22 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.