Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2006 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

B20 cam bearing mistake 120-130

posted by  mopractice on  Thu Jan 11 04:17 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 30 23:57 CST 2010
[RELATED]


I'm about to assemble a B20 engine, the block has been wrapped in plastic and sitting on the floor since I got it from the machine shop about 3 months ago. While inspecting the oil galleys I found that the rear most cam bearing does not line up with the oil galley hole - I can't poke a wire through.

The machine shop says to bring it in and they will make it right, but this will delay me a couple weeks.

Would I being making a big mistake to drill out the bearing making sure to clean up burrs and clean throughly? It's a straight shot from the rear main bearing to the cam bearing.

What do the experts think?

Mike in Minnesota






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B20 cam bearing mistake [120-130]
posted by  mopractice  on Thu Jan 11 04:17 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.