Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Eh.. Changed wiring harness, car runs worse! 200 1987

posted by  someone claiming to be Harald on  Mon Jan 29 17:47 CST 2007 [RELATED]


I recently replaced the rotten wiring harness in my '87 240 in an attempt to solve
some intermittent starting problems. I also cleaned up the FI grounds.

Unfortunately, I now have a real problem. The car stumbles/cuts out almost continuously. Sometimes you get a couple of minutes of smooth running, but it
usually will run OK for a few seconds, then stumble and often die. Fluttering the
gas pedal is necessary to keep it running. Esp. dies when you pull up to a stop sign.

I'm sure that all the connections are correct (and are actually connected)
I have swapped out the ICU and ECU and this didn't help.

Any suggestions on things to check before I start in with the multimeter?

Harald






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Eh.. Changed wiring harness, car runs worse! [200][1987]
posted by  someone claiming to be Harald  on Mon Jan 29 17:47 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.