Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help! What am I doing wrong? I can't get the strut assembly out of the hole? 200 1990

'90 244Dl

I am attempting to replace front struts, and have been trying to get the whole assembly out of the hole. I've stood and bounced on the control arm, disconnected the rear control arm mount, in addition to moving the brake bracket so it can't hang up. I also have four coils of the spring almost completely compressed.

The outer edge of the control arm is currently lower than where it was when the wheel was on it, but I still have almost 2" to go before the top end will clear the tower hole?

Please, any suggestions will be greatly appreciated! I want out of this vehicle for humanity project, but I don't have the option of throwing a match at it at this point!

I think I can, I think I can, I think I can get Junior on the road!
ezsha
--
'84 244, Peter, never drove. Robbed to fix Paul, '86 244 - drove for 2 years; holey saint now, passing parts to Paul Jr, '90 244, yet to drive. Friends w/ '90 245, jokingly aka Mary, (pregnant sedan & completes PPM trilogy). Daughter to unnamed '90 745.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help! What am I doing wrong? I can't get the strut assembly out of the hole? [200][1990]
posted by  curiousheights  on Wed Feb 28 10:01 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.