Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

about to replace all rear bushings, should i buy a press? 200 1992

posted by  cn52x5hg on  Sat Jun 30 06:10 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 11 17:37 CST 2013
[RELATED]

when i replaced the front bushings i spent about $80 getting the CA bushings pressed in. the thought crossed my mind of buying a cheap press, but i had other things to worry about at the time.

from what i have read there are about 8 bushings on the rear end. i know i need a special tool for the rear TAB, but at the rate i was paying, i am easily at $150 in machine shop fees.

i've never used a press before, are they as simple as they look? will i have to buy anything else once i have the press? finally, is a cheap HF press OK for the occasional DIY'r?

thanks,
kevin






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New about to replace all rear bushings, should i buy a press? [200][1992]
posted by  cn52x5hg subscriber  on Sat Jun 30 06:10 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.