Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fixed my stalling problem - a loose wire going to the coil 200 1991

posted by  rf64 on  Mon Jul 2 15:28 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Mar 10 14:44 CST 2009
[RELATED]

Hello all ,well I found out why my car was stalling . One of the wires going to the coil was loose. I jiggled the wire with the engine ideling and the car stalled out. the end of the wire has a male or female end I'm not sure which one but I crimped it and put it back on the coil terminal and it went on nice and tight , and that was the whole problem. I didnt need a amm or crank sensor after all , thank god . Thanks to all. rf64






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fixed my stalling problem - a loose wire going to the coil [200][1991]
posted by  rf64  on Mon Jul 2 15:28 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.