Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Manifold pressure gauge vacuum hoses... 700

uid 34776's pic
posted by  Ryan_R on  Mon Jul 30 11:27 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 24 13:46 CST 2013
[RELATED]


I'm looking to replace the aging vacuum hoses in our 740... and the "new"
'87 240 while I'm at it.

The question I have is that both have vacuum hoses from the manifold for
engine load info to either the FI (Regina) or ignition (Volvo-Chrysler). In
both cases, the original hose is a skinny, almost see through, plastic
hose/tube with fat rubber "boots" on each end vs. the plain-jane vacuum
hose typically used for things like the fuel pressure regulator.

Can I use normal vacuum hose to go the Regina manifold pressure sensor and
Volvo/Chrysler ICU, or do I have to use tubing identical to what is already
there?... which I imagine is a specific Volvo part. Anyone BTDT?

Thanks!
-Ryan
--

Athens, Ohio
1987 245 DL 312k
1990 245 DL 133k M47, E-codes
1991 745 GL 290k (Girlfriend-mobile)
Buckeye Volvo Club






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Manifold pressure gauge vacuum hoses... [700]
posted by  Ryan_R subscriber  on Mon Jul 30 11:27 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.