Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Turbo head install 1st or exhaust/turbo in first? 200 1984

posted by  runwld2 on  Wed Aug 15 15:23 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 30 13:11 CST 2014
[RELATED]

I'm about to put the head back on (removed to have machine shop replace exhaust manifold studs). I could not get the exh/turbo assy. out past the fender with the head on, only after I removed the head. One hangup was the exhaust studs.
So, do I put the studs in the head (how tight?) drop the manifold assy into the area next to the block, then put on the head? Or should I put the head on, lower the exh manifold into place and put the studs on then?

Also got lots of little pieces with the head gasket kit, many of which I do not recognize. any list some where what comes with these kits (Elring from FCP Groton). Looks like some injector O rings (aren't those for electronic injectors?) Do mechanical injectors have O rings? Are there distributor O rings?

Have replaced the O2 sensor and the heater hose behind the block, any other items which are impossible to reach once it is all together?

All hints welcome.
--
744 & 745 GLE's (IPD a-sbars)16v M46, 245 SE(IPD a-sbars) auto, 242Ti M46(IPD springs and bars), 745GL 8v auto






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Turbo head install 1st or exhaust/turbo in first? [200][1984]
posted by  runwld2 subscriber  on Wed Aug 15 15:23 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.