Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2011 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Updated Seat Suspension 140-160

posted by  cef2lion on  Wed Oct 10 04:35 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jul 9 05:17 CST 2014
[RELATED]

My 68 144 seat suspension was missing on drivers side. I ordered the newer mesh setup from GCP along with the set of 12 springs. I installed it but ran into an issue. The mesh is U shaped on the edge with piano wire in between. One side of the mesh setup is open. Hence the U shape. The back set of springs are sliding off the at the tip of the U. Don't sure why the mesh setup isn't a complete circle with the piano wire in between. Maybe I'm trying to install it incorrectly. I sent a picture of the mesh setup to Eric from on this forum to review. Wonder if others have installed this setup and how it is done. I made a U below. The end springs are coming off each side of the tip of the U.

__________________
|
|
|
|
------------------

Craig






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Updated Seat Suspension [140-160]
posted by  cef2lion  on Wed Oct 10 04:35 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.