Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pulling on wiring harness 200

posted by  Stickbuilder on  Sun Jan 27 02:16 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 03:31 CST 2014
[RELATED]

Yesterday (and it was too damp and chilly to start the big project) I was under the hood of the 245 with the engine running. I grabbed the wire harness where it comes between runners 3 and 4 and gave it a light tug. The engine smoothed out like it has not idled in several years. The only thing was that the idle speed went up to 1000 rpm and stayed there. I jiggled the harness again, and the idle dropped, but the engine kept running smoothly. I guess that's proof that I have issues in the harness.

Bill






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Pulling on wiring harness [200]
posted by  Stickbuilder subscriber  on Sun Jan 27 02:16 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.