Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Front control arm bushing removal. 200

posted by  someone claiming to be adirondack blues on  Wed Feb 6 16:43 CST 2008 [RELATED]

FYI- just for fun, I tried removing the front control arm bushings (the small ones that are a pain to remove) from a car with 285k and many NE winters- I used my Harbor Freight C.H. Ina co. cheapo 12 ton press and an impact socket for a drift, with a short length of pipe for a receiver. A little PB blaster beforehand, a few pumps from the press, and the bushing came right out. Very easy.

I have done it before the old fashioned way, by burning, air chiseling, and swearing. It is so much easier with the press. $100 well spent. Rear bushings were easy removal as well. So much fun I might start doing my friend's bushings, just because I can.

It doesn't have to hurt.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front control arm bushing removal. [200]
posted by  someone claiming to be adirondack blues  on Wed Feb 6 16:43 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.