Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 Rear Main Seal Replacement 200 1989

posted by  Twotone on  Wed Feb 20 23:53 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Feb 4 02:50 CST 2009
[RELATED]

While replacing my M47, I am in the process of changing the rear main seal on my 89 240. Looking for any tips for pressing in the new seal without use of the Volvo tool. I have the aluminum carrier off the engine block and was planning on pressing in the seal off the car. I am concerned I will not be able to get the seal perpendicular to the crank. From speaking with a Volvo mechanic, the seal is usually replaced with the carrier in the car, and the Volvo tool uses the end of the crank to align the seal and set the depth of the seal. Any tips would be helpful. Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 240 Rear Main Seal Replacement [200][1989]
posted by  Twotone  on Wed Feb 20 23:53 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.