Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Starla Exhaust Clamps 200 1988

posted by  MoncureWW on  Thu Feb 21 15:40 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Apr 8 21:06 CST 2013
[RELATED]

My indy mechanic just installed my Starla exhaust from FCP. There are some leaks where the axle pipe meets the rear muffler, and where the rear muffler goes to the S shaped exhaust. Any recommendations on tightening the clamps / junctions between the muffler and the pipes? Could they have mixed the clamps? I want to get a good seal and get rid of the hissing. I can completely hold the end of my exhaust with my bare hand and exhaust leaks out through the junctions. Is this normal on this exhaust or should I demand an install sans these small leaks? Should there be a 100% seal? Will the leaks affect anything?
Thanks in advance.
Webb






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Starla Exhaust Clamps [200][1988]
posted by  MoncureWW  on Thu Feb 21 15:40 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.