Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2011 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

940 T-belt... how wide should it be? 900 1994

Hello guys,

After noticing a little slapping and ticking under the T-belt cover recently I had a chance today to pull the cover open and check it out. I was very surprised to see a very narrow belt riding off the front of the camshaft and idler pulleys. The belt looks to be in good shape other than it being less than half the width of the camshaft pulley.

Between the narrow belt (normal?) and it running 1/8" off the front of the pulleys (it's cutting into a lip on the rear cover section) What am I looking at to replace it?

There isn't any oil residue in the cover so at 117,000 miles I'm not going to mess with seals, just the belt and tensioner.

Is there a DIY guide anywhere? I have a Haynes for my old '88 740. Is it similar?

Thanks,

Erwin, in Roanoke.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 940 T-belt... how wide should it be? [900][1994]
posted by  Erwin  on Fri Mar 21 08:57 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.