Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

siemens blower motor installation 200 1984

posted by  someone claiming to be Brickboo on  Mon Jun 23 05:32 CST 2008 [RELATED]

As lamented by many others, I am replacing my failed blower motor from my 1984 245. The job is as frustrating as expected but I now have the old motor out and proudly placed the new Siemens motor in.......only to find that the shaft lengths do not seem correct(short on passenger side and long on driver's). My question to those that have performed this is:
Is the Siemens motor a direct bolt in replacement or do the fan housing mounting points(3 of them) need to be modified (ground down) to accept the new motor.
It is possible that I have the motor in backwards but I do not think that is my problem.
Any sage advise before I modify anything would be much appreciated.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New siemens blower motor installation [200][1984]
posted by  someone claiming to be Brickboo  on Mon Jun 23 05:32 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.