Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Oil pressure gauge sending unit install question 200 1986

posted by  Xraybob on  Mon Jun 30 09:24 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

I purchased an oil pressure gauge with wiring harness and sending unit. I looked in my Bentley Book and it only showed a spot where the oil pressure test gauge would go in front of the oil filter and behind the alternator. I just went out to the car and glanced in that area but only see where the oil light switch wire comes out from the side of the block. Where will I place the sending unit and is there a site that shows a wiring diagram? My car is a
non-turbo B230F engine.

Thanks for looking and any advice.
--
'86 sedan with 388,000 miles on the original engine and automatic transmission






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil pressure gauge sending unit install question [200][1986]
posted by  Xraybob  on Mon Jun 30 09:24 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.