Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Smoke after repairing flame trap hose 200 1985

Yesterday, after I found the hose to the flame trap split, I replaced the hose, and shot some solvent down the tube. The seperator is clear, You can blow through it and with the oil filler cap off, there is no inteference. This morning I drove to the office, and I noticed while I was pulling in to the parking lot, that there was some grey (light) smoke from the tailpipe. At lunch, I drove about one block and didn't notice any. On the drive home, I again noticed some light grey smoke, and after pulling into the driveway, I could tell that it is fairly constant. If I let the engine idle for a few minutes, the smoke diminishes, but if I rev the engine, I get some puffs of the smoke. Do I just need to let the solvent cook off, or should I change the oil, or have I caused some damage?

Bill
--
Those who beat their swords into plowshares will surely plow for those who did not.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Smoke after repairing flame trap hose [200][1985]
posted by  Stickbuilder subscriber  on Tue Jul 15 10:57 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.