Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

My 93 245 just lost its temp gauge 200 1993

uid 44629's pic
posted by  Luke H on  Fri Sep 5 06:27 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Mar 20 10:54 CST 2009
[RELATED]

As of last week, my temperature gauge is reading flat cold at all times. I pulled the sender wire connection and put dielectric grease on it and all that, but that didn't even make it twitch. I'm guessing that compensation board inside of the cluster is dead.

So when I jumper the outter solder leads, do I ALSO have to totally remove the board from the cluster? Or can I just jumper without having to unsolder the board?

It was a point of confusion when I read about the procedure elsewhere.


EDIT: Looks like the board pulls right out like computer RAM, so nevermind.


EDIT EDIT: Can I test my temperature sender by grounding the yellow wire to the engine block and looking at the gauge???






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New My 93 245 just lost its temp gauge [200][1993]
posted by  Luke H  on Fri Sep 5 06:27 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.