Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2005 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine Build Photos 120-130

This past week was a little nuts with carbs coming on and off and on and off again...Saturday I got the new fuel pressure regulator installed and built a new hardline for the engine (new flex lines were required as well). I thought I'd start a photo thread as Dale (245GTI) came down from Calgary to lend a hand (2.5 hour drive!) and brought his fancy camera.

Here's the new lines, pressure gauge, and FPR installed.










We then hooked up the 4th gear lockout switch and the reverse lights...things are insanely clean.




A few details.







Then we bled the clutch and brakes and went for a drive...who needs a hood, headlights, turn signals or bumpers?



My two 2-doors meet for the first time...



Back to the garage...for more finish work...fast. The transmission shifted great, brakes are very good, valves need to be adjusted again, and I've got an oil leak out the valve cover (IPD rubber gasket is terrible).



Thanks for all the assistance.

Craig






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine Build Photos [120-130]
posted by  122_Canadian  on Sun Nov 9 07:54 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.