Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2012 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

help with camshaft seal on 740 NA 700

posted by  KlausC on  Wed Nov 12 05:17 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

The seal on one of the 1989 740s leaks badly. Even at idle, at engine start up, I can see the oil leaking out of the tbelt cover about 1 inch below the top on the passenger side.

Question: Could I try to push the seal back in place? Without removing the tbelt? Just pry it back in?

I realize the flame trap is probably completely clogged and caused this problem in the first place.

Chilton's says to remove the fan before removing the tbelt cover??? Isn't there enough room to just unbolt the cover and lift it up? It is 35F here and I don't want to be exposed to the elements very long. They look like 10mm bolts.

Thanks,
Klaus

--
Just driving a 1998 V70R :)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New help with camshaft seal on 740 NA [700]
posted by  KlausC subscriber  on Wed Nov 12 05:17 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.