Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 8/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Blower motor blues 200 1990

posted by  tbags on  Sat Nov 15 03:58 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Nov 15 06:35 CST 2008
[RELATED]


Yes I put it off all summer and now I have no choice, complete failure, resistor too.
2 questions:
Is the chain saw method doable on a 90? I was in there yesterday, and as I expected, the impellars were difficult to get off, heat did the trick on one side, the other side, the shaft is peened a bit, but anyway looking into the motor and mounting screws I'm thinking this is impossible, square peg round hole impossible. Are Arts' change outs on cleanflametrap specific to pre 90?

Question 2. might have to go the portable heater route till tuesday any recomendations on a portable heat source.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Blower motor blues [200][1990]
posted by  tbags  on Sat Nov 15 03:58 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.