Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing heater inlet hose.... 200 1993

posted by  runwld2 on  Thu Jan 22 07:39 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 30 13:11 CST 2014
[RELATED]

....without removing the manifold?
I had thought this was possible, but after spending 2 hours yesterday, and only getting the heater end off, not so sure. Seems impossible to get at the screw clamp and remove, and later put on, the end at the head.
Should I order an intake manifold gasket, or does anyone have a trick?
--
84 242Ti IPD bars&springs, 89 745 16v M46 IPD bars, 89 744 16v M46 IPD bars, 90 745 AW70, 91 245SE AW70 IPD bars, 93 245 CLassic M47






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing heater inlet hose.... [200][1993]
posted by  runwld2 subscriber  on Thu Jan 22 07:39 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.