Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2001 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bending back the radiator support after deer hit!!! 900

posted by  matt82dl on  Thu Jan 29 12:41 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 13 10:46 CST 2014
[RELATED]

So my wife hit a deer a few weeks ago. The was on the driver's side square in the headlight and grille. I finally have my new hood all painted, headlight, brackets, trim, turn signal and grill all ready to go.

I installed the new hood as well as the latches and springs and noticed the drivers radiator support has been pushed back approximately 3/4" - 1".

Its dark and cold now so tomorrow I need to figure out a way to pull out the radiator support back into position. The pocket for the hood spring is located in the radiator support so I have no chance of getting the hood to close until I get this support bent back into position.

I could just yank on it with my hands and possibly wrench my back.
I could beat it from behind with a 5 lb sledge and a 2x4.
Or try and pry it somehow.

Looking forward to hearing from the bodywork experts out there.

Thanks,
Matt


--
'90 245 224k, '93 945 184k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bending back the radiator support after deer hit!!! [900]
posted by  matt82dl  on Thu Jan 29 12:41 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.