Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Auto Trans output seal leaks - seal-only or seal AND bushing? 200 1988

posted by  jon_h on  Fri Feb 6 05:19 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:57 CST 2014
[RELATED]

AT has a small leak at output seal. PM seems worthwhile here.

Was about to replace seal and in reading FAQ here I see that folks often replace the bushing. But it isn't clear why.

Is it that: The bushing wears -> lets the output shaft wobble -> wears out the seal?

This shaft isn't loose and there's no vibration so I just assumed the seal had lost it's elasticity over time & miles.

Should one always replace the bushing; or only when the shaft is loose?

And as I understand it in the FAQ: you can do the seal on the trans; and do the bushing on the trans if you have a specialized puller. But if you don't have the puller you have to pull the tailshaft and drive it out?
--
240s: 2 drivers and some parts cars






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Auto Trans output seal leaks - seal-only or seal AND bushing? [200][1988]
posted by  jon_h  on Fri Feb 6 05:19 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.