Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hard Starting and engine stumble until .... 200 1993

posted by  J.R. on  Tue Feb 10 14:45 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Feb 1 20:22 CST 2011
[RELATED]

Already did a search and saw a variety of answers. Need some advice.

Hard Starting when cold soaked (it's been between low 20F and 32F here in the morning. Cranks a long time, then it tries to catch. Crank again for a long time and then it fires. Rough at idle and some stumbling until the engine temp needle starts to move.

I'm 99.99999% sure there is no cold start injector and based on some searched posts, the computer keeps the injectors open longer during cold start. So the possibilities so far are:

- IAC sticky (will pull and check freedom of movement and clean if necessary)
- Temp sensor bad (will check resistance at the sensor using the numbers from Bentley's manual)
- Wiring from temp sensor to computer bad (same test as above)

Any other thoughts on items I should be checking?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hard Starting and engine stumble until .... [200][1993]
posted by  J.R.  on Tue Feb 10 14:45 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.