Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Driveline? vibration 200 1993

I have had a singing/whining/wailing sound from somewhere under the car for a few months now. It is related to car speed, not engine speed. It occurs mostly during the initial 5 minutes, and only at lower speeds.
Now there is a vibration in the body. Not much below 40mph, obvious at 43, and more so from 50-70.
Also get some jerking starting off at low speeds, thought it felt like a poor mixture, but maybe it's a different form of the vibration.
Car had code for idle air solenoid, but it works OK with the ECU test sequence operating it, but I get an idle which will "hang" at 1500 for about 10seconds before coming down.
Under the car, I twisted the driveshaft, checked for play in the universals, and pushed at the center bearing. I can get the whole rubber doughnut to move 1/2 inch, but no looseness. Not sure how much movement in doughnut is acceptable.
How to tell if bearing needs replacement? How stiff should that doughnut be?
(from a crossword last weekend, a doughnut should be called a torus I guess).
--
84 242Ti IPD bars&springs, 89 745 16v M46 IPD bars, 89 744 16v M46 IPD bars, 90 745 AW70, 91 245SE AW70 IPD bars, 93 245 CLassic M47






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveline? vibration [200][1993]
posted by  runwld2 subscriber  on Sat Feb 28 16:39 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.