Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

So if the clutch fork is bending... 200

posted by  transit wind on  Sat Feb 28 19:57 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 15 22:40 CST 2014
[RELATED]

...the transmission has to come out and while there the pressure plate resurfaced and a new rear seal if leaking and a new pilot bearing since they are cheap? Read a post that made replacing a M46 clutch seem too much work or so the poster was told by others. One thing I don't understand is that I read about how the bell housing has to be turned 90 degrees. It that 90 degrees a twist in place or to get it out from under the car or would you even move the transmission from under the car? I think the clutch fork is bending since my new clutch cable is starting to go out of wack after a couple weeks. Sucks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New So if the clutch fork is bending... [200]
posted by  transit wind subscriber  on Sat Feb 28 19:57 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.