Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

What is involved in removing the intermediate shaft on a 240 b230f?

posted by  rstarkie on  Sat Jun 13 10:33 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:14 CST 2014
[RELATED]

I went to the Pull and Pay today to get a set of timing belt covers.

I had the opportunity to grab an intermediate shaft with the distributor drive gear on it- someday I am going to get around to dropping a b230ft into a 240.

I took the seal carrier off and pulled the distributor but was only able to extract the shaft about 6" before it hung up.

Does the oil pump have to be removed in order to get the shaft out?

Randy






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What is involved in removing the intermediate shaft on a 240 b230f?
posted by  rstarkie subscriber  on Sat Jun 13 10:33 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.