So in changing the kickdown cable I now screwed up big time.Fussing with the cam to release the cable something happened.It appears as if the cam is now off center.I cannot access it.The only way to access it is to remove the lower section of the tranny,the valve body.Since I already messed things up I don't want to complicate things further.So if I remove the valve body very carefully and drop it down I think I can correct the cam problem.My concern with the valve body is that I think there are few parts in there that may move around.I remember something about some small ball bearings in a tranny.Is this correct?I just want to lower that valve body assembly and hopefully get to the cam,straighten it out,remove the old cable and replace.I need a tranny guru!Please help!