Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2016

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

If the working pressure on my fuel system is 43.5 psi

posted by  mr.zorak on  Sun Jun 21 00:41 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jul 3 10:08 CST 2014
[RELATED]

and I had to splice in a 3 inch piece of Goodyear 5/16 30R7 fuel line running to the inlet of the banjo bolt on my new fuel filter because I accidentally tore the small vinyl hose. I clamped both ends and started up fine with no leaks.

My qquestion: As this new hose is rated at 50 psi, will it be okay to leave it on here without problems till the next time I change out the fuel filter as recommended? I know it says not to use with fuel injectors, but is that for ones with higher pressures in the system than our bricks? I will get under there and put on a higher pressure rated hose if I have to, but if it can wait till next filter change it would be nice on my back!
--
93' 240 Classic Wagon 220K & 92' 740 Wagon Regina/Rex 90K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New If the working pressure on my fuel system is 43.5 psi
posted by  mr.zorak subscriber  on Sun Jun 21 00:41 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.