Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Which release bearing is best for a Sachs clutch? 200

posted by  volvo245kit on  Wed Jul 8 10:09 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Apr 30 20:54 CST 2011
[RELATED]

I bought and installed the Sachs clutch kit for my M46 on my project car and when I finally go it on the road I found that the release bearing that came in the kit is a POS. It's has an extreme vibration at about 2500- 3100 RPM's. I've replaced all of my engine,tranny and driveshaft support mounts with new and judging by the fact that it sounds like an old style bicycle bell that being thrashed about in there I'm fairly certain that it's not a mount. I hate to pul the tranny again but I'm not going to live with this then way it is. So, what's been everyone's experience with this? Do you all have recommendations as to which release bearing I should replace this with? Thanks, Charles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Which release bearing is best for a Sachs clutch? [200]
posted by  volvo245kit  on Wed Jul 8 10:09 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.