Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

shift linkage bushing--shifter end pin rusted in place. options? 200

posted by  weather on  Sun Aug 2 14:06 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 26 23:16 CST 2012
[RELATED]

tried to replace the shift linkage bushings today. the front (tranny end) one went easy enough.

however the shifter end (toward the rear) bushing pin is rusted in place. making things worse, taking the shifter end linkage off was impossible due to lack of room between end of stud and transmission tunnel to take the nut off. couldn't move the stud either because the shifter bin was held in place by rusted screws/nuts too.

what options do i have? is there any trick to loosen that bushing pin? thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New shift linkage bushing--shifter end pin rusted in place. options? [200]
posted by  weather subscriber  on Sun Aug 2 14:06 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.