Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Installed new AMM, '88 240 still dies right after starting 200

posted by  Boatbuilder on  Wed Aug 5 06:30 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 4 19:35 CST 2014
[RELATED]

I replaced the AMM that I thought was bad, bu the car still dies right after starting. When the AMM connector is unplugged, the engine stays running. the idle air control motor is fine, throttle position switch was replaced with a good used one a year ago, and there are no missing or cracked vacuum lines or duct hoses. What else should I suspect as the problem? I have a spare ECM, should I try replacing that as well? Thanks, Paul






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installed new AMM, '88 240 still dies right after starting [200]
posted by  Boatbuilder  on Wed Aug 5 06:30 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.