Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Drive Belts from a/c compressor? 200 1983

posted by  Laccrosse1 on  Thu Aug 20 13:32 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 31 03:22 CST 2010
[RELATED]

Hi, I am just finishing a head gasket replacement on my 240 and I am struggling with the getting drive belt from the a/c compressor back onto the crank sprocket. I cannot find the slide bolts on the a/c compressor. Also, I am a bit confused with the proper arrangement of these sprockets. There are 3 of them that fit inside each other with little metal separating discs that go between them. Then the 3 separate parts are bolted together with 6 bolts. I think I have the proper alignment of these 3 parts, but I was wondering if anyone had any input or even better a picture or 2 of the proper alignment.
Thanks for any help!
Trevor







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.