Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

U Joints + Center Support DIY 200 1988

posted by  WB81 on  Tue Sep 22 02:17 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 1 15:35 CST 2011
[RELATED]

I'm dropping the driveshaft in the 244 and having the 3 U Joints replaced and a new center support bearing pressed on. I'm bringing in the parts from FCP. I've called a local machine shop and asked about the cost to which the owner said, "I'll have to look at them to give you a total." Which to me means, "I'll have to see how much I can get out of you ???."

What does this job typically cost? My father and I have pressed bearings before, it takes 10 minutes and very little effort. What about the joints?

Any real life cost totals would help. I don't want to loose my shirt over this one.

Thanks,

WB






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New U Joints + Center Support DIY [200][1988]
posted by  WB81  on Tue Sep 22 02:17 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.