Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Coupe rear floor section - flat vs pressed 120-130

posted by  tdskip on  Wed Oct 14 02:43 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Nov 13 21:12 CST 2011
[RELATED]

Hi guys - about ready to suck it up and buy replacement panels since finding original ones hasn't panned out yet. My '68 122s has rear floor section with an indentation, or recessed/lowered, section. I believe this is what the "pressed" replacement panels are referring to.

The pressed panels are more than twice the cost of the flat section, and I'm wondering if it is possible to modify/trim the flat section to work on my recessed original pressing. Probably not, but I figured it is worth asking.

Thanks!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Coupe rear floor section - flat vs pressed [120-130]
posted by  tdskip subscriber  on Wed Oct 14 02:43 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.