Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2020 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

New Header Pipe and possibly a Catalytic Converter...Suggestions? 200 1990

State inspection is in Dec. (no emission test needed).

I need:

1. Header Pipe (no EGR and I need it with a fixed flange)-I was thinking about the Volvo part from IPD ($150)

2. Front Muffler & Axle Pipe (I figured I would get Starla, but I think I remember someone on here saying the Volvo exhaust parts from Tasca were less $$$)

3. ***HERE IS THE PROBLEM***-pretty sure I am probably in need of cat. converter (way back a mechanic put in faulty O2 sensor and it was running rich for a long time. It is not rusted through but I have a feeling that it is dead.

I need one with fixed flanges, no EGR and I need it to have O2 sensor hole.

As I have searched this forum I have seen all the info about cat converters and header pipes not fitting correctly. So I need suggestions on what works/fits correctly and doesn't fail after two years!

I might tackle this job myself, but I don't know about those pesky header pipe studs and dropping and replacing the entire exhaust system as I am somewhat of a beginner in DIY.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New New Header Pipe and possibly a Catalytic Converter...Suggestions? [200][1990]
posted by  1990Volvo240 subscriber  on Mon Oct 26 07:10 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.