Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Tips on control arm installation (front suspension) 200 1985

posted by  ricbelley on  Sat Oct 31 05:50 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jan 18 12:32 CST 2014
[RELATED]

I had to remove the front suspension control arm to replace bushings.
I red that you must tighten the CA rear bushing nut, front bushing bolt / nut, rear bushing bracket bolts only with suspension loaded: wheels on the car, and on the ground.
Does anyone have some tips as to how to access the rear bushing nut for final tightening?
I mean: If the car is off jack stands with the wheels on, I would not have any room to allow me to reach out to bushing nut inside the control arm bracket???

Thanks for the help






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tips on control arm installation (front suspension) [200][1985]
posted by  ricbelley  on Sat Oct 31 05:50 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.