Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2010 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Wagon rear bumper overider 120-130 1967

posted by  KlausC on  Wed Nov 18 07:16 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

Someone in the past hit the RR bumber overider, with the rubber top, and managed to bend it. It now rattles a lot and is loose. My intent is to pound it out so that at least the sides are straight and it no longer rattles with every bump.

I sprayed PBBlaster into the overider but to no avail. It appears to be rock solid. I don't want to destroy this nice piece of chrome with over-torquing. Is there something I should be doing differently? Removing the whole bumper seems over kill and I will still have this rusty bolt problem. Besides, it seems it is full of leaves,twigs,dirt,etc.

Klaus
--
Proud owner of a 220S. If I had more room, I would have more Volvos.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Wagon rear bumper overider [120-130][1967]
posted by  KlausC subscriber  on Wed Nov 18 07:16 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.