Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Control Arm Rear Bushing Torque 200 1989

posted by  NewMexico240 on  Tue Mar 2 13:06 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:52 CST 2014
[RELATED]

I replaced the rear bushing on the driver side control arm today.
The Bentley Manual says to lower the car after the nuts and bolts
on the control arm bushings are on finger tight and then after bouncing the car and rolling the car back and forth you can torque the two bushings bolts.
I could not get my torque wrench to fit inside the rear bushing bracket
(very limited space), so
I had to pull the control arm off again, torque the rear bushing inside
its bracket and then re-install the control arm.
Is there another way that I should of torqued that rear bushing?

BTW, the clunk sound is now gone from the driver side wheel area.

Joseph in NM






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Control Arm Rear Bushing Torque [200][1989]
posted by  NewMexico240 subscriber  on Tue Mar 2 13:06 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.