Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Need special tool for front rear bushing. 200 1982

posted by  nabramson on  Sat Apr 10 18:13 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 20 15:00 CST 2011
[RELATED]

The small rear bushings in front of the trailing arm are "shot-2-$#!+ " & need to be replaced. I can hold off on the large TAB'a @ this time.If I can just lower the rear trailing arm by disconnecting the front bushing bolt & rear shock absorber @ the bottom, I figure I can lower the front of the trailing arm enough to work on the rear bushing. Is there a C-clamp tool that can be recommended that is specifically for suspension work that I can turn out the rear front bushing & install the urethane bushings I got from FCPGroton ? Is there a Sears tool # for example? I have a 12 ton press but if I can bypass removing the trailing arms & stabilizer bar it would make this job a snap !






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need special tool for front rear bushing. [200][1982]
posted by  nabramson subscriber  on Sat Apr 10 18:13 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.