Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Cylinder Head Gasket Holes Don't Match Up 200 1993

posted by  stogeyman on  Sun Apr 11 10:25 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jun 13 18:07 CST 2014
[RELATED]

This normally aspirated 93/240 had what appeared to be a blown cylinder head gasket. I just pulled the head and sure enough the gasket is shot. Here's the thing. There are holes in the block (I assume for coolant) that don't exist on the cylinder head. Is that normal for these cars?

BTW, sorry about the confusing subject line. I noticed this because I pulled the head gasket off the block to confirm a head gasket failure and noticed white residue (burnt coolant) on spots on the gasket.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Cylinder Head Gasket Holes Don't Match Up [200][1993]
posted by  stogeyman  on Sun Apr 11 10:25 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.