Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2010 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Collapsable (68+) steering shaft "pins' 120-130

posted by  red92s on  Mon Apr 12 12:23 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 18 13:02 CST 2014
[RELATED]

I've been refurbing one of the not-impale-your-chest steering box/shaft assemblies for installation into my '67. When I picked it up from a parts pile it only had one of the "pins" that goes through the small bushings which link the two halves of the shaft.

Seems they are available from Volvo, with the new bushing and sleeve, but at a cost of about $30 each. I've already got a pair of the IPD poly bushings on hand.

My plan was to simply cut the head off a shoulder bolt and turn the end down to match the taper on the OEM one I have. But, I can't find a shoulder bolt with quite the same outside diameter. A 3/8" shoulder fits pretty well with virtually no slop, but isn't quite as tight of a fit as the OEM one through the bushing.

I guess plan B is to go up to the next diameter of shoulder bolt, and ream out the bushing holes to provide a nice tight fit. But before I do that, I figured I'd ask if anyone has any better ideas, or maybe even has one in a parts bin somewhere?

Some pictures for clarification:





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Collapsable (68+) steering shaft &quot;pins' [120-130]
posted by  red92s subscriber  on Mon Apr 12 12:23 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.