Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2015 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Prop shaft question 120-130 1967

When I replaced 2 U joints, I did not make very good marks on the prop shaft before disassembly. Needless to say, the front half might not be correct. The U joints no longer all point in the same direction.

IF it has been put on 'wrong', what will the consequences be? All seems to be smooth at 60 mph. At 70 mph, my hood/bonnet shakes, but that could be due to out of balance tires?

The rear half of the prop shaft has been replace correctly, just not sure of the front half that goes through the center bearing.

Klaus
--
Why are Volvos so endearing? Its just a car.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Prop shaft question [120-130][1967]
posted by  KlausC subscriber  on Wed May 26 06:27 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.