Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help!! Seats Apart, Different Wiring on Drivers Seat Back! 900

posted by  someone claiming to be 960 Brickster on  Thu Jul 29 02:23 CST 2010 [RELATED]

I have both a drivers and passenger seat back off my 95 960 sedan. But the drivers seat has different wiring. It has a Large green sheathed lead that seems to go to the air bag sensor, with a large grey plug with four wires to the plug: Green, yellow/red. The seat heater lead is the same.

Not sure what I am going to do here as both seats are apart and I don't have the hog rings or hog ring pliers as I did not anticipate there being a seat back difference.

So I can't drive to the shop to pick up anything and am stuck until I figure this out. I need help here asap if anyone has done this.

I think I have 3 options:

1. Only replace the seat bottom and leave put the old seat back on again for now.

2. Remove the skins from each seat so wiring stays the same

3. Figure out what driver seat wiring is for/means, and see if I can disconnect it and move to the new seat back.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help!! Seats Apart, Different Wiring on Drivers Seat Back! [900]
posted by  someone claiming to be 960 Brickster  on Thu Jul 29 02:23 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.